Quick overveiw of my 150g antweight robot 'Johnny Mnematic'

It is a heavily modified lego ram with a RC aircraft fill valve and a VM1000 valve operated by a micro HV servo. The drive is two N20's from BBB with the esc being a Malenki Nano rx/ESC combo unit. It runs off a custom built 160mah 2s lipo (old turnigy nanotech cells)
The wheels are custom printed with foam tires and gears built in which allow it to be 6wd. The air tank is a c02/nos cartridge I found outside a pub. The chassis is 3d printed ABS and the armour is a mixture of 0.75mm and 1mm polycarbonate.

This video is not intended to be a "how to" guide as I don't want to encourage people too much down this route. I go back to the flamethrowers on robots mindset, if you have to ask how, then you shouldn't be doing it. I will be as helpful as possible answering questions but a lot of the setup should come from research and safe testing. I stand by pneumatics being as if not more dangerous than spinning weapons. Be smart, even when you're being dumb.

Feel free to check out my other builds (and more pictures of this one) on my FB page
  / 100057175851376